Uploaded image for project: 'Minecraft: Java Edition'
  1. Minecraft: Java Edition
  2. MC-128866

Water source blocks do not always create new sources

XMLWordPrintable

    • Icon: Bug Bug
    • Resolution: Duplicate
    • None
    • Minecraft 18w16a
    • Unconfirmed

      Whenever water source blocks have solid blocks directly underneath them, they form infinite springs (renewing the source block when grabbed with an empty bucket) as intended. If flowing water or air is under the source block however, it DELETES the block without refilling it, without updating neighboring blocks.

      Steps to reproduce:

      I created a 2x2 green platform with walls around, filled it with two water source blocks and it made a full 4 source blocks.

      When i remove one green block and dig down an extra block (leaving air under the water source on the surface) then i can grab from the surface of any green block and the water refills properly. But, trying to get the water in an empty bucket from the space where it flows downwards makes the nearby sources flow to it. You in fact remove that water source and it does NOT replace itself.

      I made a taller container with complete source blocks covering the entire floor.

      When I add water to the next layer, it doesn't flow sideways to create source blocks.

      Even a complete ring around the edges doesn't fill in the middle.

      To fill in the middle, solid blocks must be placed under the 2nd layer source blocks. This updates them and they immediately create extra source block as expected normally.

      Removal of the temporary blocks that let you fill in the 2nd layer shows a full 2 layer deep pond.

      Using an empty bucket on ONLY the 2nd layer of water source blocks reveals that the bottom layer is no longer source blocks, and also doesn't fully drain either. It is a mixture of source and non-source blocks, even though the entire floor was replaced with solid blocks and then broken out once the 2nd layer of water was in place.

      This leads to weirdness in survival. I don't have a screenshot to show of it, but in my own world, I spent around an hour "fixing" my ocean beside my base. I walked by and snagged a bucket of water from the surface and it didn't refill, leaving a lone air block in the surface of the natural ocean. I grabbed from elsewhere near by to try to fill it back in and was unsuccessful. The more I tried to fill it in, the more holes I was eating out of the surface of the ocean. My solution ended up being to build a roof 1 block over the entire area and fill it in, manually, one block at a time. I didn't get a screenshot of it, but the core symptom was easy to repeat in a test world as above.

        1. 8 - bug.png
          8 - bug.png
          965 kB
        2. 7 - full2.png
          7 - full2.png
          974 kB
        3. 6 - bug.png
          6 - bug.png
          921 kB
        4. 5 - donut.png
          5 - donut.png
          910 kB
        5. 4 - castle.png
          4 - castle.png
          1018 kB
        6. 3 - full1.png
          3 - full1.png
          726 kB
        7. 2 - bug.png
          2 - bug.png
          343 kB
        8. 1 - normal.png
          1 - normal.png
          387 kB

            Unassigned Unassigned
            rpgbuster Kenneth Taylor
            Votes:
            0 Vote for this issue
            Watchers:
            1 Start watching this issue

              Created:
              Updated:
              Resolved: